Recent content by 1911

Yes, I understand the ACD/ SCR configuration and I do have a MSB configured The Handset is in the correct port. Thanks, I'll keep looking.

OK, my mistake, but it's all the same. All the phones are programmed on customer 0, I had tried customer 1 to see what would happen. I have the 3905 programmed the same as the above configuration, but on customer 0 and all my other sets are on customer 0. I can call from the 3905 to the other...

I get dial tone on the 3905 set and I can call out to various inhouse extensions, I just can't receive a call.

Yes

I try to call the 3905 from another set and I always get a busy signal. I just programmed this and I did not put Virtual there. Why is it there? See below. TYPE: 3905 TN 004 0 04 00 DATE PAGE DES DES LAB TN 004 0 04 00 VIRTUAL TYPE 3905 CDEN 8D CTYP XDLC CUST 1 KBA 1 ERL...

I think if I just asked a question at a time, it would give me a better understanding. Hopefully someone has the patience to work with me. I have a Avaya Aura 6.2 midsize system with a Session Manager, a G430 Gateway with a MM714 analogue trunk/ line module. I am receiving caller id, but need to...

As I indicated, this is a test system as we develop Avaya and Cisco SIP Attendant Consoles. I only have a single trunk set up. That trunk will process all calls to my VDN 10000. Unfortunately our carrier doesn't provide DNIS service, but we have a requirement by a customer to process the Dialed...

This is a test system where I have only a SIP trunk installed.

Avaya CM 6.2. I have a VDN, 10000 to a vector that sends calls to a hunt group which rings the first available agent. I'd like that agent to receive the DNIS name so they know who the call was actually for, i.e. 10000/ VDN01. I'm having trouble figuring out what to configure to make this happen...

OK, here's the two traces. From 21020 to 949 7567160. The first trace is a failed attempt, the second a successful attempt. I dialed 9 949 7567160 then 9# 949 7567160. list trace station 21020 list trace station 21020...

9 1 FAC. This is it.

OK, thank you for the help. No hurry, I'll get the traces ASAP.

I have 9 for my feature access code to the ARS not 9# or 9*. I then have a single entry in my ARS ANA for 9 with 10min/ 10max to route pattern 1 to trunk 1. Again, it does work with TAC and 9#. Otherwise not.

Give me a few and I try to get one.

smokinjoe2938, that is correct. The entry 9 with 7min/ max digits was already there so because my service provider requires the fill 10 digits for an out going call, I put the 949 with 10/ 10. I just removed that and change the 9 to 10/ 10. Either work just fine if I dial 9 # then my 10 digit...