Recent content by bennuss

Recntly got involved with IT for a company that has an avaya system . I am trying to get connect to It . the old company said the password is default and if i cant connect I must be using the wrong version. I tried with 11 which was giving me a secure communications error and I tried with r7...

If i swap them to I need to get licensing or what i have for the digital will cover the swapped analog modules

We have an avaya ip office install in a long term care that has multiple digital modules (non ip) and multiple analog modules for resident phones. We have stopped using the digital modules since we switched to different ip based voip solution. We would like to utilize the digital ports for...

It is if your ip based. I have all digital phones which i would have to replace.

Ok. Have to see if it pays. I can move to 3cx and buy new phones for probably the same cost and have a modern system.

I know there are no pri licenses visible but the system is working fine with a digital pri coming into a grandstream . I need some explanation? If I upgrade will it continue to work fine?

This all that shows. But my lines work fine and I have had 16 simultaneous calls .

On the control unit it shows slot1 port T1PRI number of channels 23 number of administered channels 23 In slot 1 port 2 it shows not in use. Thats all i see as far as channels. Where do I look?

I have an ip office 500 v2 on version 9.0.5.0 build 972. I would like to update my system to 11. Do i have to get a new PRI license . Right now I have a 23 line digital pri coming into a grandstream GXW4501 which is connected to the ip office . I am asking because i am getting different answers...

Any interest in a remote job even to just evaluate. Not sure if this is allowed on the forum . If not just ignore.

No idea. I believe its embedded . How do I get basic training or hire someone even to remote in and look at it.

The vm keeps going done and when i reboot it it starts working again. Ay ideas ? Been managing this for a couple of months . Not really something I know but not too complicated . Also need to know the process in adding phones. Right now all the phones are digital . Can i add ip phones ? how...

I have added the card ta82461 to allow it to wring my phones but i am not sure how to get it to actually wring my phones. I see two phone jacks is that the wiring from the door bell buttom or does that connect to a jack in the main card? Also when i press the button by the door i hear it -...

The dhcp that I should set is the one under network setup, not the the automatic configuration DHCP under internet connection type correct? The smc is 192.168.2.1 so I should set the linksys AP to 192.168.2.10. The WDS to 192.168.2.11 and the netgear to 192.168.2.12 Correct? The netgear settings...