Recent content by rdoubrava

Hello I'm on an SE running ip phones at 14 different locations. Current version is 11.1.0.1.0 build 95 (system started at 9.1) I have always believe this was a bug in the software. If I reboot the phone system. Some phones auto login, some phone sit at a login prompt. Totally random I have...

The issues I have seen. Button mapping on the 56xx series phones disappear or doesn't work. Phone just have an a, b, c button to make/take calls. Call log - time is wrong Phone "locks up" or is frozen - needs a reboot

Are you on the latest version of 9.0 ?. Are you using VOIP phones ?

Does your carrier support E911 Part of the Law is that it needs to go to the correct 911 center (PSAP) for that location.

You don't have any choices if using analog phone lines.

not bandwidth, you need QoS

Equinox/IX Workplace only works on R11.

This was a change on R10. I like the change critchey solution works

I had a similar requirement several years ago. This was a legal requirement due to an automotive warranty claim. We had to do the recording on the trunk side.

There is a temporary failure at the physical layer on the ISDN network The only thing you can do is replace the cable between the IP Office PRI. This is a carrier issue

What software version ?

I had a similar problem on our system. I have increase the number to 50 on our system. You have to restart the vmpro service. Avaya doesn't recommend increasing the number. I haven't had any issues with using 50.

Sounds like to me You have a routing loop. LAN and Wan are on the same network.

Are the SIP trunks with the same provider ? Our provider does this for us. Site A goes down. Phones fallback to site B. provider switches inbound traffic to Site B.

RTM, you need R11 on the IP office