Recent content by Sniffmaster

Hi, Have you ever loaded Sniffview console to access a DSS on the dolch unit? Just wondering..

Just wondering...Are you also loading Sniffview console on the Distributed Sniffers?

Make sure in Sniffer Pro you only have TCP/IP bound to one ethernet card. That will be the card sending the snmp commands to the switch. Also make sure that is not the card pluged into the span port. Cheers

Network Informant was replaced by Sniffer Watch.

http://www.iana.org/assignments/ethernet-numbers

Hi, Barniclebill is right...Use Snifferbook Ultra with the Gig module. You also get realtime Expert during capture with Snifferbook Ultra from your laptop. With the PCI Gig card expert is post capture. Or use our new improved Gigabit distributed and the config options are many and you get RMON...

Hi, I installed 4.7 and it was slow in loading trace files as well as slow in displaying after capture. I uninstalled, cleaned out the registry and reinstalled. Now it runs with no problem. I loaded a 17K file and it displays in 14 sec. This is on Dell laptop 1 gig with 256 mg ram. There were...

and Cisco 4003 4006..

The switch patches are available and supported..all you have do is ask.

Hi, For Distributed we have a 2 port and a 4 port wan (RS/V). The 2 port can run 8mg on each port so that could keep you happy. Also we offer a distributed in a 2 port wan, 1 port 10/100 Ethernet so you can span and monitor those ethernet devices in the switch at the same time you look at the...

wrong...Our OC-3 will work with STM-1

No Packet gen for DSPro..sorry..Portable only

Hi, STM1 is available for DSS and portable. We use the ATMbook for both for Sniffer analysis.

Hi, ATM DSS is available with OC-3 MMF OC-3 SMF OC-12 MMF OC-12 SMF UTP 155-copper DS3 E3 T1/E1

Sniffer Voice must be installed over Sniffer Portable (version 4.5 and higher). So 4.6 no problem.