Recent content by telcoguy

Do a "display announcement", and see if the announcements got a protected Y flag? otherwise do a "list trace station" <your extension> while dialing the fea, and see if it comes back with a denial reason.

Looks like you do not have a lot of experience in this field and trying to learn. That is ok. We can't design your network for you, but we can help you to get there. Cisco makes a set of very good design guides which will give you the general idea's, and specifics on how to get things done. Take...

The error means: Certificate Expired Exception. This is thrown whenever the current Date or the specified Date is after the not After date/time specified in the validity period of the certificate. Looks like you got a certificate error, I have no clue how to fix that one, but I think it says...

ok, in that case.. I found the doc for you here. I could not find it in the Official Avaya archives anymore :-) But really, choosing the right emulation should fix the keymapping, unless the terminal setting got erased. You should be able to type the emulation on the screen you get after...

When using the Avaya site administration client you should be ok using the 4410, or ATT513 emulation. When using another terminal emulation you have to map the keys.. In the FAQ section there are a few docs on this like: http://www.tek-tips.com/faqs.cfm?fid=1728

There are some development kits available through the Avaya DEVCONNECT site.

OK, if you are using Layer2 switches , ie 2960's and they are in the same VLAN you should be OK. The broadcast stays in the same broadcast-domain. If you are using Layer3 switches, ie 3560,3750,3560,3650,4500, or there is another routing device in between, then you need to set up...

Are your PC's on the same VLAN when they are plugged behind the phone as they would be as plugged in directly? Generally speaking a pc needs to be in the same layer 2 network as the pc that sends the WOL-Packet, in order to receive the broadcast, unless the routers in between forward the...

Do a 'list trace sta xxxx(your phone) while making a call, If that looks ok do a "list trace TACxx" on the far end , and see if the call makes it there. if that doesn't clear up things post the results here.

Depends on the connector: 120 ohm for RJ45 75 ohm for a set of coax connectors.

I don't know if they told you the reason, It looks like a bug, they said they fixed: Long term solution: Upgrade to SMGR 6.3.9 as this issue is fixed. Defect number is wi01170683 titled "System Manager web console becomes unresponsive due to accumulation of hornetQ messages associated with...

Bobsiko, does the CD boot in a diffrent system, like an old PC? (careful, I can't remember if it erases the HDD yet at this point). or perhaps a virtual machine.. It will probably not install, but you can check if this specific disk boots, and if yes if it shows any errors. I had my share of...

Cross or not depends on the other device. Using brooktrout cards in the past I always had to cross. For straight a regular CAT5 cable will do. for cross RJ45 PIN: 1:4 2:5 3:3 4:1 5:2 6:6 7:7 8:8

You have a corrupted system, This is an Avaya job unfortunately. Like mentioned above, "need to have SES ADE engaged for that" (application team) I doubt you would have the required access rights. Get in contact with Avaya, and mention you have an issue like described in SOLN231209.

You need specialist help to solve this. This error has to do with a bug that causes the partition assigned to SES to run out of space. According to Avaya: Solution: SES filesystem needs to be cleaned up, need to have SES ADE engaged for that. However, the root cause is: this problem is caused...