Search results for query: *

Can I give certain users rights to logoff other users off without giving them any other administrator privileges?

Is there a fix to the poor sound quality and clipping on partner phones hooked up to a magix. The phones worked fine on the partner but on the magix the customer is saying the speakerphones suck.

I know the the 517M15 does not cooperate with 016 cards and the 517E15 is the preferred card but to any of the earler release cards do O.K. When set for PRI I have a 517C15 I would like to use

Is there a way using MONITOR to see what digits the C.O. is sending over a tie line. I have a customer with a Quest LD T1 and they are supposed to be sending 400 which is the calling group number of teh voice mail but all of the calls are goine to the operator. They have DNIS on another T...

Is there an easy way to block dialing 1010 numbers on a Legend R7V14.2. I dont have my test system set up to figure it out.

Twice in the past week I have been subbed to do a cutover to a T1 on the Legend. Both R7's Neither one of them would disconnect when the far end hung up(on 2 different providers) It is usually an option that is set in the channel bank but the T's were directly into a 100D card so there was no...

Can a PRI be configured on a legend so the first 15 channels come in and give line appearances, and the and the Last 8 channels be CALL BY CALL for 2way DID operation. Don

What is the difference between a Merlin Messaning 1 and a merlin Messaging 1.1

I don't do a whole lot of fiber and to make it easy I use the Lightcrimp plus system from Amp. It is very easy BUT the fibers just barely pass or barely fail. It may be the fiber scanner but has anyone else had any problems with them. Thanks

Docs are on avaya's support site

I have a system and the CO is not sending a CPC -co disconnect signal. It is a 5E switch that comes to my customer through a PG cable. I talked to the guy at the CO and he has NO IDEA what I am calling about. Every Voice mail messasge ends woth BEEP BEEP BEEP if you woulld like to make a...

I went to oder a T1 card for the partner and was informed that they had problem with them that caused the system to crash. It this true? I have one going in next week and this is BAD news if it is true. -Don

I have noticed on the avaya support page. http://suppoer.avaya.com >communications systems>partner ACS>R6> there is a smdi card that is used for screenpops etc. Can it be true? It seems promising -Don

The avaya support site now has R6 documentation. GOOD JOB AVAYA KEEP UP THE GOOD WORK

It's on the support.avaya.com site but no specific docs. Does anyone have any info? Thanks

hi, How do you do a TTR test on a pertner ACS. I remember that there is a way to do it but I forget. Don

Does anyone have any info on the Magix 2.2? Thanks Don

Here It is Goto HTTP://www.support.avaya.com Choose Communications Systems Choose Partner Choose ACS Choose Software Downloads Choose #2: Partner ACS Remote Administration Software Downloads Don

I Have a PRI on a legend R7V14.2 That shows OOF between the 100D-U and the CSU. It seems to show up mostly when Dialing. I have the clock/Sync source as Slot 10 (which is where the 100D-U card Resides Any Ideas?

What is the Merlin Mail 7.4 Is it a variation of the Merlin Mail R3. I have in the past only seen the R2 and R3 and in the past 2 weeks i have seen 2 of these. you usually don't see this release mentioned much. Any Ideas?